Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- sa_ahcomm:device_setup [09.11.2005 14:21 (vor 21 Jahren)] – angelegt cwacha
+++ sa_ahcomm:device_setup [16.11.2016 23:18 (vor 10 Jahren)] (aktuell) – Externe Bearbeitung 127.0.0.1
@@ Zeile 1: / Zeile 1: @@
+===== iPAQ Initialization =====
+  - Hard-Reset the Devices by pressing and holding Button 1 (Calendar) and 4 (iTask) simultaneously and then pressing the Resetbutton (using the Pen) for more than 2 seconds. Press the Reset-Button again to powerup the device
+  - After the iPAQ has booted for the first time, complete the introduction and wait until the device has rebooted.
+  - Use the iPAQ Backup application to restore Base-xx.pbf (the File can be found in ./sa_ahcomm/ FIXME).
+  - Under Settings->System->About->Device ID set the //Device Name// to ahcomm-XX where as XX represents the last two digits of the TIK-Inv. number.
+===== Active Sync with Computer =====
+  - Place the device into the cradle and wait until the New Partnership dialog opens
+  - Choose //Standard Partnership//
+  - Choose //Synchronize with this computer//
+  - Choose //No, I want to synchronize with two computers// (You can only sync with a max. of 2 computers)
+  - Deselect all conduits
+  - Click Finish
+Remark that you have to sync twice so that the time will get updated too!
+If you want to connect a device to a third computer, use guest mode instead.
+Alternatively you can also choose //Guest Partnership//. No synchronization is done in this mode but you have
+to click the Wizard away every time you connect the device with the computer.
 ===== Settings used for Base Backup =====
@@ Zeile 22: / Zeile 45: @@
+==== Create the Backup ====
 The Backup was created directly on the iPAQ using the iPAQ Backup Tool
@@ Zeile 28: / Zeile 52: @@
   - Select System Data Folder
   - Backup