===== iPAQ Initialization =====

  - Hard-Reset the Devices by pressing and holding Button 1 (Calendar) and 4 (iTask) simultaneously and then pressing the Resetbutton (using the Pen) for more than 2 seconds. Press the Reset-Button again to powerup the device
  - After the iPAQ has booted for the first time, complete the introduction and wait until the device has rebooted.
  - Use the iPAQ Backup application to restore Base-xx.pbf (the File can be found in ./sa_ahcomm/ FIXME).
  - Under Settings->System->About->Device ID set the //Device Name// to ahcomm-XX where as XX represents the last two digits of the TIK-Inv. number.

===== Active Sync with Computer =====

  - Place the device into the cradle and wait until the New Partnership dialog opens
  - Choose //Standard Partnership//
  - Choose //Synchronize with this computer//
  - Choose //No, I want to synchronize with two computers// (You can only sync with a max. of 2 computers)
  - Deselect all conduits
  - Click Finish

Remark that you have to sync twice so that the time will get updated too!
If you want to connect a device to a third computer, use guest mode instead.

Alternatively you can also choose //Guest Partnership//. No synchronization is done in this mode but you have
to click the Wizard away every time you connect the device with the computer.


===== Settings used for Base Backup =====

(for instructions on how to use the backup refer to the Active Sync Howto)

Settings:

  * Sound off
  * Settings->About->Device ID->Device Name = ahcomm-NEW
  * Owner->Name = ahcomm-NEW
  * Menus: everything deactivated except File Explorer
  * Menus: New Menu: everything deactivated except Note
  * Today: Theme Windows Default
  * Today: Items: Date, Owner Info, TodayPanel activated - others deactivated
  * Backlight: Brightness On Battery set to minimum value
  * Clock & Alarms: Timezone: Berlin, Rome (GMT+1)
  * Power: Advanced: Device should run all the time
  * Power: USB Charging deactivated to save battery charge cycles
  * Beam: Receive all incoming infrared beams deactivated
  * Regional Settings: Time adjusted (24h)
  * Regional Settings: Date adjusted (dd-MMM-yy)
  * iPAQ Wireless: Network Adapters: HP iPAQ Wi-Fi Adapter: IP set to 192.168.0.0/24


==== Create the Backup ====
The Backup was created directly on the iPAQ using the iPAQ Backup Tool

  - Switch to advanced mode
  - Unselect all
  - Select System Data Folder
  - Backup